Canyon 2WD L5-3.5L VIN 6 (2004)
7. Remove the rear cover and gasket from the differential housing.
8. Drain the rear axle.
Installation Procedure
1. Clean the contact area for the rear cover and gasket and the differential housing.
2. Install the retainer and mounting bracket for the rear brake pipe.
3. Install the mounting bolt for the mounting bracket.
4. Finger tighten the bolt for the mounting bracket.
5. Install the axle housing cover and gasket.
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the mounting bolts.
^
Tighten the mounting bolts to 30 Nm (20 ft. lbs.).
