Canyon 2WD L5-3.5L VIN 6 (2004)
4. Measure the amount of torque required to rotate the pinion. Use an inch-pound torque wrench. Record this measurement for reassembly. This will
give the combined preload for the following components:
^
The pinion bearings
^
The pinion oil seal
^
The differential case bearings
^
The axle bearings
^
The axle seals
5. Place an alignment mark between the pinion and the pinion yoke.
6. Install the J 8614-01 as shown.
7. Remove the pinion nut while holding the J 8614-01.
8. Remove the washer.
