Canyon 2WD L5-3.5L VIN 6 (2004)
Important: Failure to align the reference marks properly will cause a vibration the propeller shaft.
4. Position the yoke on the propeller shaft so that the reference marks are aligned properly.
5. Using a brass or hard rubber hammer, lightly tap the yoke on the propeller shaft.
6. Install the washer.
Notice: Refer to Fastener Notice in Service Precautions.
Important: Tighten the retaining nut by hand before tightening the retaining nut to the proper specifications.
7. Install the retaining nut.
^
Tighten the retaining nut to 167 Nm (123 ft. lbs.).
8. Align the U-Joint to the reference marks on the propeller shaft and yoke.
9. Install the U-Joint to the yoke.
10. Remove the shop towels from the propeller shaft.
11. Install the propeller shaft in the vehicle.
