Canyon 2WD L5-3.7L (2007)
3. Remove the backing from the front end of the emblem/nameplate.
4. Press the emblem/nameplate to the tailgate surface while continuing to remove the backing.
5. Hand roll the emblem/nameplate to the tailgate panel to ensure proper adhesion.
6. Inspect the emblem/nameplate for bonding.
7. Remove the tape from the area around the emblem/nameplate.
Pickup Box Side Emblem/Side Rear Nameplate Replacement (Canyon 2WD)
Pickup Box Side Emblem/Side Rear Nameplate Replacement (Canyon 2WD)
Tools Required
J 25070 Heat Gun
Removal Procedure
Important: Use the tape for protection and alignment marks for alignment of the new decal.
1. Apply tape to the area around the decal.
2. Heat the decal, using a J 25070, 152 mm (6 in) from the surface.
3. Apply the heat using a circular motion for about 30 seconds.
Notice: Refer to Exterior Trim Emblem Removal Notice.
4. Remove the decal from the painted surface using a plastic, flat-bladed tool.
5. Remove all adhesive from the painted surface using 3M(TM) ScotchBrite molding adhesive remover disk 3M(TM) P/N 07501 or equivalent.
6. Clean the painted surface using varnish makers and painters (VMP) naptha.
7. Remove the tail lamp.
Installation Procedure
