Canyon 2WD L5-3.7L (2007)
Remove the old sunroof window seal (1) from the frame (2). Refer to Sunroof Window Seal Replacement in SI.
Install the new seal. Refer to Sunroof Window Seal Replacement in SI.
Condition 4
A leak from around the sunroof glass holder clip, known as a"blow out clip" (1).
Cause 4
A lack of adhesive sealant under the sunroof window holder clip.
Correction 4
Remove the sunroof window holder clip and apply a small amount of CRL7711 Sealant in the upper frame clip using the steps below.
Remove the power sunroof motor. Refer to Power Sunroof Motor Replacement in SI.
Remove the lower sunroof frame. Refer to Sunroof Frame Replacement-Lower in SI.
Remove the two screws from the sunroof gear plate.
Remove the gear plate.
Remove the gear.
Remove the two screws for the sunroof glass holder clip.
Apply a 2 mm (1/16 in) bead of CRL7711 Sealant to the upper sunroof frame clip area.
Install the glass holder clip.
Tighten the two screws.
Tighten
Tighten the two screws to 1 N.m (9 lb in).
The chamfered edge of the gear goes toward the motor when reinstalling the gear.
Install the gear.
Install the gear plate and two screws.
Tighten the two screws.
Tighten
Tighten the screw to 2 N.m (18 lb in).
Install the lower sunroof frame. Refer to Sunroof Frame Replacement-Lower in SI.