Canyon 2WD L5-3.7L (2007)
16. Remove the seat back heater element.
Installation Procedure
1. Install the seat back heater element.
2. Position the seat back pad to the seat back frame.
3. Connect the electrical connector to the seat back heating element, if equipped.
4. Partially install the seat back cover over the top of the seat.
5. Install the head restraint guides to the seat frame. Ensure that the locking tabs are fully seated. The guide with the release tab goes on the
right-hand side.
6. Install the hog rings that retain the seat back pad to the reinforcement bar.
7. Pull the seat cover (1) over the seat back pad (3).
8. Press the seat cover hook and loop retaining strips (2) together by firmly running your hand over the seat back cover (1).
9. Install the J-strip (1) across the bottom of the seat back cover.
10. Install the head restraint.
11. Install the seat cushion outer trim panel.
12. Install the seat back release handle.
13. Install the seat in the vehicle.
Front Seat Back Frame Replacement
Front Seat Back Frame Replacement
Removal Procedure
1. Remove the seat from the vehicle.
2. Remove the seat back cover and pad.
