Canyon 2WD L5-3.7L (2007)
1. Remove the masking from the cylinder head and ensure the sealing surface is clean and dry.
2. Install a NEW seal into the intake manifold groove.
3. Position the intake manifold to the cylinder head.
4. Raise and support the vehicle only high enough to access the following components through the wheelhouse Refer to Vehicle Lifting.
*
The intake manifold bolts
*
The engine wiring harness bracket bolts
*
The wiring harnesses
Notice: Refer to Fastener Notice.
5. Install the intake manifold bolts.
Tighten the bolts from the inside working outward to 10 N.m (89 lb in).
6. Position the engine wiring harness bracket to the engine.
7. Install the engine wiring harness bracket bolts.