Canyon 2WD L5-3.7L (2007)
Caution: Refer to Relieving Fuel Pressure Caution.
6. Pull the connection apart.
7. Using a clean shop towel, wipe off the male pipe end.
8. Inspect both ends of the fitting for dirt and burrs.
Clean or replace the components as required.
Installation Procedure
Caution: Refer to Fuel Pipe Fitting Caution.
1. Apply a few drops of clean engine oil to the male pipe end.
2. Push both sides of the quick-connect fitting together in order to cause the retaining feature to snap into place.
3. Pull on both sides of the quick-connect fitting to make sure the connection is secure.
4. Inspect for leaks using the following procedure:
1. Turn the ignition ON, with the engine OFF for 2 seconds.
2. Turn the ignition OFF, for 10 seconds.
3. Turn the ignition ON, with the engine OFF for 2 seconds.
4. Turn the ignition OFF.
5. Inspect for leaks.