Canyon 2WD L5-3.7L (2007)
Body Control Module: Service and Repair
BODY CONTROL MODULE REPLACEMENT
REMOVAL PROCEDURE
IMPORTANT:
-
The ignition switch should be in the OFF position when connecting or disconnecting the connectors to the body control module (BCM).
-
Always disconnect the black body wiring harness connector FIRST and the gray instrument panel (I/P) wiring harness connector LAST.
-
Always connect the black body wiring harness connector FIRST and the gray I/P wiring harness LAST.
-
Do not open the BCM housing. The module does not have any serviceable components. The module may be replaced only as an assembly.
1. Ensure the ignition switch is in the OFF position.
2. Remove the right front hinge pillar trim panel.
3. Disconnect the body wiring harness electrical connector (1) from the BCM.
4. Disconnect the I/P wiring harness electrical connector (1) from the BCM.