Canyon 2WD L5-3.7L (2007)
Shift Solenoid: Service and Repair
Control and Shift Solenoids Replacement
Removal Procedure
1. Remove the transmission oil pan and filter. Refer to Automatic Transmission Fluid and Filter Replacement.
Important: Do not remove the valve body for the following procedures. Removal of the 1-2 accumulator is necessary only if servicing the
pressure control solenoid.
2. Remove the 1-2 accumulator if necessary. Refer to Accumulator Assembly, Spacer Plate, and Gaskets.
3. Disconnect the internal wiring harness electrical connectors from the following components:
*
Transmission fluid pressure switch (1)
*
1-2 shift control solenoid (2)
*
2-3 shift control solenoid (3)
*
Pressure control solenoid (4)
*
TCC PWM solenoid (5)
*
3-2 control solenoid (6)
4. Remove the pressure control solenoid retainer.
5. Remove the pressure control solenoid.
6. Remove the 1-2 and 2-3 shift solenoid retainers with a small screwdriver. Rotate the solenoids in the bores, if necessary, until the flat part of the
retainers are visible.