Canyon 2WD L5-3.7L (2007)
Shift Cable: Service and Repair
Automatic Transmission Range Selector Lever Cable Replacement
Automatic Transmission Range Selector Lever Cable Replacement
Removal Procedure
1. Ensure the vehicle is in the park position.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Important: Do not pull on the boot portion of the cable.
3. Complete the following in order to disconnect the range selector cable (3) from the transmission range selector lever ball stud.
1. Insert a flat bladed tool between the range selector cable end (5) and the range selector lever (1).
2. Pry the range selector cable end (5) away from the range selector lever (1).
4. Remove the retainer (4) from the range selector cable (3).
5. Push the range selector cable locking tabs inward toward each other to release from the bracket (2).
6. Push the cable grommet (1) up through the floor panel (2).
7. Lower the vehicle.
8. Remove the left hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement - Left Side.
9. Pull the drivers side carpet up, enough to access the range selector cable.
