Canyon 2WD L5-3.7L (2007)
Pressure Regulating Solenoid: Service and Repair
Control and Shift Solenoids Replacement
Control and Shift Solenoids Replacement
Removal Procedure
1. Remove the transmission oil pan and filter. Refer to Automatic Transmission Fluid and Filter Replacement.
Important: Do not remove the valve body for the following procedures. Removal of the 1-2 accumulator is necessary only if servicing the
pressure control solenoid.
2. Remove the 1-2 accumulator if necessary. Refer to Accumulator Assembly, Spacer Plate, and Gaskets.
3. Disconnect the internal wiring harness electrical connectors from the following components:
^
Transmission fluid pressure switch (1)
^
1-2 shift control solenoid (2)
^
2-3 shift control solenoid (3)
^
Pressure control solenoid (4)
^
TCC PWM solenoid (5)
^
3-2 control solenoid (6)
4. Remove the pressure control solenoid retainer.
5. Remove the pressure control solenoid.
6. Remove the 1-2 and 2-3 shift solenoid retainers with a small screwdriver. Rotate the solenoids in the bores, if necessary, until the flat part of the
retainers are visible.