Canyon 4WD L4-2.9L (2008)
3. Connect the upper control arm to the ball stud by installing the retention nuts.
Tighten the nut to 47 N.m (35 lb ft).
4. Connect the wheel speed sensor brackets.
5. Install the wheel speed sensor bracket bolt.
Tighten the nut to 20 N.m (15 lb ft).
6. Connect the front brake hose to the upper control arm. Refer to Front Brake Hose Replacement (See: Brakes and Traction Control/Hydraulic
System/Brake Hose/Line/Service and Repair/Front Brake Hose Replacement) .
7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair) .
8. Remove the lower control arm support.
9. Lower the vehicle.
10. Verify the wheel alignment. Refer to Wheel Alignment Specifications (See: Alignment/Specifications) .
