Canyon 4WD L5-3.5L VIN 6 (2004)
5. Locate and remove the two fasteners that retain the adjuster bar to the inner and outer seat adjuster assemblies.
6. Remove the adjuster bar. Note that the bar is curved upward at the front.
7. With the adjuster bar removed, inspect the inboard and outboard plastic adjuster blocks for any damage where the adjuster bar engages into the
holes in the adjuster blocks. If any damage is detected, the affected seat adjuster assembly must be replaced. The seat adjuster assemblies are
available individually (inboard and outboard). Only replace the component that is damaged.
Refer to Manual Seat Adjuster Mechanism Replacement in SI for replacement procedures.
8. Install the revised adjuster bar. When installing the bar, do not apply pressure to the outer ends of the bar, it may bend at the pivot mount holes.
Ensure that the curved portion of the bar is in the upward position.
9. With the bar installed, inspect the area where the adjuster bar engages the inboard and outboard adjuster blocks. Ensure that there is no gap
between the two components.
10. Reinstall the seat. Refer to Front Seat Replacement - Bucket or Split Bench Seat Replacement in SI.
11. Before tightening the seat mounting bolts, ensure that the inboard and outboard seat tracks are parallel and spaced 305 mm (12 in) apart as shown.
12. With the seat installed, verify the seat adjuster function.
Parts Information
