Canyon 4WD L5-3.5L VIN 6 (2004)
4. Connect the roof rail module connector (1) and install the garnish molding.
5. Connect the seat belt pretensioner-left and install the CPA.
6. Install the trim panel.
7. Connect the side impact sensor yellow 2-way connector (5) located near the middle of the door.
8. Install the CPA (3) to the side impact sensor yellow 2-way connector (5) located near the middle of the door.
9. Install the left door trim panel.
10. Connect the I/P module yellow 4-way connector located under the I/P module.
11. Install the CPA to the I/P module yellow 4-way connector located under the I/P module.
