Canyon 4WD L5-3.5L VIN 6 (2004)
Knock Sensor: Service and Repair
Knock Sensor (KS) 1 Replacement
KNOCK SENSOR (KS) 1 REPLACEMENT
REMOVAL PROCEDURE
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the engine wiring harness electrical connector from the KS (2).
3. Remove the KS retaining bolt.
4. Remove the KS (2) from the engine block.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the KS (2) and the retaining bolt to the engine block, positioning the electrical terminals down.
Tighten
Tighten the knock sensor (KS) bolt to 25 N.m (18 lb ft).
2. Connect the engine wiring harness electrical connector to the KS (2).
3. Lower the vehicle.
