Canyon 4WD L5-3.5L VIN 6 (2004)
4. This step applies to Q Release style connectors ONLY. Release the fitting by Pushing the tab toward the other side of the slot in the fitting.
5. This step applies to Squeeze to Release style connectors ONLY. Squeeze where indicated by arrows on both sides of the plastic ring surrounding
the quick-connect fitting.
6. This step applies to Sliding Retainer style connectors ONLY. Release the fitting by pressing on one side of the release tab causing it to push in
slightly. If the tab doesn't move try pressing the tab in from the opposite side. The tab will only move in one direction.
CAUTION: Refer to Relieving Fuel Pressure Caution in Service Precautions.
7. Pull the connection apart.
8. Using a clean shop towel, wipe off the male pipe end.
9. Inspect both ends of the fitting for dirt and burrs. Clean or replace the components as required.
INSTALLATION PROCEDURE
CAUTION: Refer to Fuel Pipe Fitting Caution in Service Precautions.
1. Apply a few drops of clean engine oil to the male pipe end.
