Canyon 4WD L5-3.5L VIN 6 (2004)
Caution:
When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Refer to SIR Disabling and
Enabling Zones. Failure to observe the correct procedure could cause deployment of the SIR components, personal injury, or unnecessary SIR
system repairs.
Repair Information
1.
Gain access to the front seat belt retractor/pretensioner connector and wiring.
^
On regular cab models, remove the rear corner trim panel.
^
On extended cab models, the front seat belt retractor is located in the rear door. Remove the rear door trim panel to gain access to the
retractor/pretensioner.
^
On crew cab models, remove the lower center pillar trim panel.
Important:
On extended cab models, inspect the seat belt retractor/pretensioner wiring located in the rear doors. Also inspect the wiring between the door
and the body for signs of chaffing/damage.
2.
Disconnect and Reconnect the appropriate seat belt retractor/pretensioner two wire connector to insure a proper connection.
3.
With a scan tool, inspect for a current DTC.
^
If a current DTC is still present, refer to the Diagnostic Information above.
^
If a current DTC is not present, continue with the next step.
4.
With a scan tool, clear the DTC history information.
Warranty Information
