Canyon 4WD L5-3.5L VIN 6 (2004)
Service Procedure
Important:
There are two switches above the brake pedal - the cruise control switch (1) and the stop lamp switch (2). The cruise control switch is in the
outboard position and the stop lamp switch is in the inboard position.
1.
Disconnect the cruise control switch connector (1) and stop lamp switch electrical connector (2).
2.
Rotate the stop lamp switch (2) counterclockwise.
3.
Remove the stop lamp switch (2) from the bracket.
4.
Remove the stop lamp switch (2) from the vehicle. Discard the stop lamp switch (2).
5.
Inspect the stop lamp switch retainer.
^
If the stop lamp switch retainer is not broken, proceed to Step 6.
^
If the stop lamp switch retainer is broken, replace the retainer and then proceed to Step 6.
6.
Position the new stop lamp switch near the bracket.
7.
Ensure that the switch key-way is properly indexed to the plastic retainer.
8.
Install and adjust the stop lamp switch.
8.1
Rotate the switch counterclockwise, allowing the retainer to release.
8.2
Pull the brake pedal rearward to full stop.
Important:
Do not move the brake pedal during switch adjustment as this will cause an over-adjusted switch which could cause brake drag.
8.3
While holding the brake pedal FIRMLY in position rearward, push the switch inward fully until the switch body contacts the brake pedal
arm striker plate. At this point the plunger in the switch should be pushed in.
8.4
Rotate the switch clockwise until a "click" is heard.
8.5
The switch is properly adjusted when there is 7 mm (0.028 in) clearance between the end of the switch barrel and the striker plate on the
brake pedal arm.
