Canyon 4WD L5-3.5L VIN 6 (2004)
Shackle: Service and Repair
Spring Shackle Replacement
^
Tools Required
-
J 36660-A Angle Meter
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Support the rear axle at ride height.
3. Remove the shackle nut and the bolt from the frame.
4. Remove the shackle nut and the bolt from the spring.
5. Remove the shackle assembly from the vehicle.
Installation Procedure
1. Install the shackle assembly to the spring.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the shackle nut and bolt to the spring.
^
Tighten the rear shackle nut to 85 Nm (63 ft. lbs.).
3. Install the shackle nut and bolt to the frame.
^
Tighten the shackle nut to 85 Nm (63 ft. lbs.).
4. Remove the rear axle support.
5. Lower the vehicle.