Canyon 4WD L5-3.5L VIN 6 (2004)
2. Route the range selector cable through the dash mat.
3. Connect the range selector cable retainer (2) to the lower dash panel (1).
4. Install the range selector cable (4) to the steering column bracket (5).
5. Install the retainer (3) to the range selector cable (4).
6. Push the range selector cable end (2) onto the range selector lever ball stud (1) to secure.
7. Reposition the drivers side carpet to the floor panel.
8. Inspect below the accelerator pedal for binding, to ensure full range of motion.
9. Install the left hinge pillar trim panel.
10. Raise and support the vehicle.
11. Install the range selector cable (3) to the bracket (2).
12. Install the retainer (4) to the range selector cable (3).
13. Remove and discard the primary lock lockout pin if a new cable is being installed.
14. Adjust the automatic transmission range selector cable.
15. Lower the vehicle.
