Canyon 4WD L5-3.7L (2007)
1. Install the wheel cylinder to the backing plate.
Notice: Refer to Fastener Notice.
2. Install the wheel cylinder mounting bolts.
Tighten the wheel cylinder mounting bolts to 18 N.m (13 lb ft).
3. Remove the rubber plug from the brake line.
4. Install the brake line to the wheel cylinder.
5. Install the brake line fitting.
Tighten the brake line fitting to 19 N.m (14 lb ft).
6. Install the rear brake shoes.
7. Bleed the brake system.
8. Lower the vehicle.
9. Check the fluid lever in the master cylinder.
