Canyon 4WD L5-3.7L (2007)
7. Remove the bolt and gaskets from the brake caliper.
8. Remove the brake hose from the brake caliper.
9. Remove the copper gaskets from the brake hose bolt. These gaskets may stick to the brake caliper or the brake hose bolt.
Installation Procedure
Important: DO NOT reuse the old copper gaskets. Always use NEW metal copper gaskets.
1. Install the copper gaskets on the brake hose.
Notice: Refer to Fastener Notice.
2. Install the brake caliper bolt to the brake caliper.
Tighten the brake hose bolt to 40 N.m (32 lb ft).
3. Remove the plug or cap from the exposed brake pipe fitting.
4. Install the brake hose to the brake pipe.
Important: Ensure that the brake hose is not twisted and does not come in contact with any of the suspension components.
5. Using a backup wrench on the brake pipe fitting, tighten the brake hose fitting.
Tighten the brake hose fitting to 17 N.m (13 lb ft).
