Canyon 4WD L5-3.7L (2007)
Important: The rear oil pan surface needs to be flush with the rear block surface.
4. Use the following applicable step to properly align the oil pan:
*
Transmission Removed
Use a straight edge at the rear of the block and oil pan for proper alignment.
*
Transmission Installed
Ensure the oil pan is positioned fully rearward against the transmission mounting surface.
5. Install the oil pan bolts.
Notice: Refer to Fastener Notice
6. Tighten the oil pan bolts.
*
Tighten the (side) oil pan bolts to 25 N.m (18 lb ft).
*
Tighten the (end) oil pan bolts to 10 N.m (89 lb in).
7. Connect the engine wiring harness retainers to the oil pan.
8. For the 4WD only, position the power steering gear upward to the frame assembly.
9. For the 4WD only, install the power steering gear mounting bolts.
