Canyon 4WD L5-3.7L (2007)
10. Remove the exhaust camshaft position actuator.
Installation Procedure
1. Ensure the camshaft actuator is fully advanced prior to installation.
2. Install the exhaust camshaft actuator into the timing chain.
Aligning the marked link (1) on the timing chain with the timing mark (1) on the exhaust camshaft position actuator sprocket.
Notice: The camshaft actuator must be fully advanced during installation. Engine damage may occur if the camshaft actuator is not fully advanced.
Important:
*
To aid in aligning the actuator to the camshaft, use a 25 mm (1 in) wrench on the hex of the camshaft to rotate.
*
Ensure the alignment pin is properly engaged with the camshaft.
*
Ensure the camshaft actuator is rotated clockwise relative to the camshaft prior to tightening the bolt. Do not force the camshaft
actuator to rotate clockwise. If it does not move easily, it is already fully advanced. New camshaft actuators are already packaged
in the fully advanced (clockwise) position.
Install the exhaust camshaft actuator onto the exhaust camshaft.
Notice: Refer to Fastener Notice.
