Canyon 4WD L5-3.7L (2007)
Steering Shaft: Service and Repair
Steering Column Shaft Replacement (Tilt Column)
Steering Column Shaft Replacement (Tilt Column)
Tools Required
J 21854-01 Pivot Pin Remover
Removal Procedure
Caution: Refer to SIR Caution.
1. Disable the SIR system.
2. Remove the tilt spring.
3. If necessary, remove the linear shift assembly.
Remove the electrical brake transmission shift interlock (BTSI) actuator.
4. Remove the turn signal cancel cam assembly. Refer to Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement.
5. Remove the ignition switch and lock housing. Refer to Ignition and Start Switch Replacement.
6. Remove the upper intermediate steering shaft.
7. Remove the lower shaft bearing assembly.
8. Remove the pivot pins (1) using J 21854-01.
9. Pull the tilt arm in order to disengage the steering wheel lock shoes from the dowel pins (2) in the steering column support assembly.
