Canyon 4WD L5-3.7L (2007)
5. Connect the upper ball joint to the steering knuckle and install the retaining nut.
Tighten the nut to 75 N.m (55 lb ft).
6. Connect the outer tie rod to the steering knuckle.
7. Connect the wheel speed sensor harness to the chassis harness.
8. Connect the wheel speed sensor harness to inner fender panel.
9. Install the brake caliper bracket.
10. Install the new wheel drive shaft nut.
11. Install the tire and wheel.
12. Remove the control arm support.
13. Lower the vehicle.
14. Verify the wheel alignment. Refer to Wheel Alignment Specifications.
