Canyon 4WD L5-3.7L (2007)
Important: Do not attempt to hold the stabilizer shaft link near the boot. Use the hex feature on the end of the stud. Failure to do so could
damage the boot.
1. Install the stabilizer shaft link.
Notice: Refer to Fastener Notice.
2. Install the stabilizer shaft link mounting nuts.
^
Tighten the stabilizer bar link lower mounting nut to 44 N.m (32 lb ft).
^
Tighten the stabilizer bar link upper mounting nut to 44 N.m (32 lb ft).
3. Remove the axle support.
4. Lower the vehicle.
