Canyon 4WD L5-3.7L (2007)
Fluid Line/Hose: Service and Repair
Transmission Fluid Cooler Hose/Pipe Replacement
Transmission Fluid Cooler Hose/Pipe Replacement
Removal Procedure
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Disconnect the transmission fluid cooler lines from the radiator. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting
Replacement.
3. Remove the transmission fluid cooler lines from the retainer located on the radiator.
4. Remove the transmission fluid cooler lines from the retainer located on the right side of the engine.
5. Support the transmission with a transmission jack.
6. Remove the transmission support. Refer to Crossmember Replacement - Transmission (2WD).
7. Remove the front exhaust pipe assembly. Refer to Catalytic Converter Replacement (2WD), (4WD).
8. Carefully lower the transmission to gain access to the transmission fluid cooler line fittings.
9. Disconnect the transmission fluid cooler lines from the transmission.
10. Remove the transmission fluid cooler lines from the vehicle.
Installation Procedure
1. Install the transmission fluid cooler lines to the vehicle.
2. Install the transmission fluid cooler lines to the transmission.
Notice: Ensure that the cooler line being installed has a plastic cap on each end that connects to a quick connect fitting. If no plastic cap exists, or
the plastic cap is damaged, obtain a new plastic cap and position on to the cooler line prior to the cooler line installation.
