Canyon 4WD V8-5.3L (2009)
Rear Door Weatherstrip: Service and Repair
Rear Side Door Wedge Replacement - Body Side
Rear Side Door Wedge Replacement - Body Side
Removal Procedure
1. Open the rear side access door.
2. Apply tape to the area around the wedge to protect the paint.
3. Heat the wedge (1) using a heat gun 152 mm (6 in) from the surface.
4. Apply the heat using a circular motion for about 30 seconds.
5. Remove the wedge from the body using a plastic, flat-bladed tool.
6. Remove all adhesive from the body using 3M Scotch Brite molding adhesive remover disk 3M P/N 07201, or equivalent.
7. Clean the body surface using varnish makers and painters (VMP) naptha.
Installation Procedure
