Canyon 4WD V8-5.3L (2009)
5. Remove all adhesive from the door panel surface and the back of the emblem/nameplate using 3M(TM) scotch brite molding adhesive remover
disk 3M(TM) P/N 07501 or equivalent.
6. Clean the door surface using varnish makers and painters (VMP) naphtha.
Installation Procedure
1. If the location of the emblem/nameplate has not been marked, apply tape and use the following dimensions:
*
Dimension (a) is 251 mm (9.88 in) from the bottom of the door to the emblem/nameplate.
*
Dimension (b) is 157 mm (6.18 in) from the front of the door to the front of the emblem/nameplate.
2. Warm the door surface with a J 25070 ,152 mm (6 in) from the surface to a minimum of 21°C (70°F).
Important: Do not touch the adhesive backing of the emblem/nameplate.
3. Remove the backing from the front end of the emblem/nameplate.
4. Press the emblem/nameplate to the door panel surface while continuing to remove the backing.
5. Hand roll the emblem/nameplate to the door panel to ensure proper adhesion.
6. Inspect the emblem/nameplate for bonding.
7. Remove the tape from the area around the door emblem.
Pickup Box Side Emblem and Side Rear Nameplate Replacement
Pickup Box Side Emblem and Side Rear Nameplate Replacement (Canyon 4WD)
Special Tools
