Canyon 4WD V8-5.3L (2009)
Note:
*
Do not use the crankshaft oil seal or the engine front cover gasket again.
*
Do not apply any type of sealant to the front cover gasket, unless specified.
*
The special tools in this procedure are used to properly align the engine front cover at the oil pan surface and to center the crankshaft front oil
seal.
-
All gasket surfaces should be free of oil or other foreign material during assembly.
The crankshaft front oil seal MUST be centered in relation to the crankshaft.
-
The oil pan sealing surface at the front cover and engine block MUST be aligned within specifications.
-
An improperly aligned front cover may cause premature front oil seal wear and/or engine assembly oil leaks.
1. Install the front cover gasket (3), front cover (2), and bolts (1).
2. Tighten the cover bolts finger tight. Do not overtighten.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
Note: Start the tool-to-front cover bolts. Do not tighten the bolts at this time.
3. Install the J 41480 .
Tighten the tool-to-engine block bolts to 25 Nm (18 lb ft).
