Canyon 4WD V8-5.3L (2009)
6. Position the catalytic converter rearward enough in order to allow clearance to remove the seal.
7. Remove and discard the exhaust manifold seal (1).
Installation Procedure
1. If the right side seal was removed, position the catalytic converter rearward enough in order to allow clearance to install the seal.
2. Install a NEW exhaust manifold seal (1).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Install the catalytic converter to exhaust manifold nuts (2) and tighten to 50 Nm (37 lb ft.
4. If removing the left side seal, position the catalytic converter rearward enough in order to allow clearance to install the seal.
5. Install a NEW exhaust manifold seal (2).
6. Install the catalytic converter to exhaust manifold nuts (1) and tighten to 50 Nm (37 lb ft).
7. Lower the vehicle.
8. Inspect for exhaust leaks.