Canyon 4WD V8-5.3L (2009)
Note: Before reinstalling the tire on the wheel, note the following items to avoid tire pressure sensor damage upon tire mounting.
*
Position the mounting/dismounting head 180 degrees from the valve stem.
*
Position the bead transition area 45 degrees counterclockwise of the valve stem.
*
Using the tire machine, rotate the tire/wheel assembly clockwise when transferring the tire bead to the inside of the wheel rim.
*
Repeat items for outer bead.
4. Install the tire on the wheel. Refer to Tire Dismounting and Mounting (See: Tires/Service and Repair/Removal and Replacement).
Note: A service replacement tire pressure sensor is shipped in OFF mode. In this mode the sensor unique identification code cannot be learned
into the body control module (BCM) memory. The sensor must be taken out of OFF mode by spinning the tire/wheel assembly above 32 km/h (20
mph) in order to close the sensors internal roll switch for at least 10 seconds.
5. Install the tire/wheel assembly on the vehicle. Refer to Tire and Wheel Removal and Installation (See: Service and Repair).
6. Lower the vehicle.
7. Learn the tire pressure sensors. Refer to Tire Pressure Indicator Sensor Learn (See: Service and Repair).
