Canyon 4WD V8-5.3L (2009)
1. Install the CKP sensor.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the CKP sensor bolt.
Tighten the bolt to 25 Nm (18 lb ft).
3. Connect the engine wiring harness electrical connector (1) to the CKP sensor.
4. Install the starter. Refer to Starter Motor Replacement (LLV/LLR) (See: Starting and Charging/Starting System/Starter Motor/Service and Repair
)Starter Motor Replacement (LH8) (See: Starting and Charging/Starting System/Starter Motor/Service and Repair).
5. Perform the crankshaft position system variation learn procedure. Refer to Crankshaft Position System Variation Learn (See: ).
