Canyon 4WD V8-5.3L (2009)
Ignition Switch Lock Cylinder: Removal and Replacement
Ignition Lock Cylinder Case Replacement
Ignition Lock Cylinder Case Replacement
Removal Procedure
1. Remove the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement (See: Ignition Lock Cylinder Replacement).
2. Remove the multifunction turn signal switch housing. Refer to Multifunction Turn Signal Switch Housing Replacement (See: Steering and
Suspension/Steering/Steering Column/Service and Repair/Multifunction Turn Signal Switch Housing Replacement).
3. Remove the shear bolt from the ignition lock cylinder case using a hammer and chisel.
4. Remove the ignition lock cylinder case.
Installation Procedure
1. Install the ignition lock cylinder case.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the ignition lock cylinder case bolt and tighten it until the head shears off.
3. Install the multifunction turn signal switch. Refer to Multifunction Turn Signal Switch Housing Replacement (See: Steering and
Suspension/Steering/Steering Column/Service and Repair/Multifunction Turn Signal Switch Housing Replacement).
4. Install the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement (See: Ignition Lock Cylinder Replacement).
5. The passlock sensor is part of the ignition switch. If replacing the ignition switch, a passlock relearn will be needed. Refer to Control Module
References (See: Testing and Inspection/Programming and Relearning).
Ignition Lock Cylinder Replacement
Ignition Lock Cylinder Replacement
Removal Procedure
1. Remove the steering column trim covers. Refer to Steering Column Trim Cover Replacement (See: Steering and Suspension/Steering/Steering
Column/Service and Repair/Steering Column Trim Cover Replacement).
2. Turn the ignition lock cylinder to the accessory position.
3. Insert the 90 degree tip of a pick type tool into the ignition lock cylinder access hole.
4. Push and hold the ignition lock cylinder retaining pin down.
