Canyon 4WD V8-5.3L (2009)
Spark Plug: Service and Repair
Spark Plug Replacement
Removal Procedure
1. Remove the spark plug wire. Refer to Spark Plug Wire Replacement (See: Ignition Cable/Service and Repair).
2. Loosen the spark plug 1-2 turns.
3. Brush or using compressed air, blow away any dirt from around the spark plug.
4. Remove the spark plug.
If removing more than one plug, place each plug in a tray marked with the corresponding cylinder number.
Installation Procedure
1. Correctly position the spark plug washer.
2. Inspect the spark plug gap. Adjust the gap as needed. Refer to Ignition System Specifications (See: Ignition System/Specifications).
3. Hand start the spark plug in the corresponding cylinder.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Tighten the spark plug.
Tighten the plug to 20 Nm (15 lb ft).
5. Install the spark plug wire. Refer to Spark Plug Wire Replacement (See: Ignition Cable/Service and Repair).
