Canyon 4WD V8-5.3L (2009)
4. Connect the body wiring harness electrical connector (2) to the ECM.
5. Engage the integral CPA retainer (1) on the body wiring harness electrical connector.
6. If a NEW ECM was installed, the ECM must be programmed. Refer to Control Module References (See: Testing and Inspection/Programming
and Relearning).
7. Install the windshield washer solvent container. Refer to Windshield Washer Solvent Container Replacement (See: Wiper and Washer
Systems/Windshield Washer Reservoir/Service and Repair).
