Canyon 4WD V8-5.3L (2009)
1. Position the rear seat belt retractor/pretensioner assembly to the vehicle.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the bolt which retains the seat belt retractor/pretensioner assembly to the body.
Tighten the seat belt retractor/pretensioner bolt to 52.5 Nm (39 lb ft).
3. Connect the electrical connector to the retractor/pretensioner.
4. Install the lower center pillar trim panel. Refer to Center Pillar Upper Trim Panel Replacement (See: Body and Frame/Interior Moulding /
Trim/Trim Panel/Service and Repair).
5. Install the front seat belt anchor bolt. Ensure that the seat belt webbing is not twisted.
Tighten the front seat belt anchor bolt to 52.5 Nm (39 lb ft).
6. Install the front seat belt upper guide with the bolt. Ensure that the seat belt webbing is not twisted.
Tighten the front seat belt upper guide bolt to 52.5 Nm (39 lb ft).
7. Install the front seat belt upper guide shoulder bolt trim cover.
8. Enable the SIR system. Refer to SIR Disabling and Enabling (See: Air Bag(s) Arming and Disarming/Service and Repair).
