Canyon 4WD V8-5.3L (2009)
4. Install the negative battery cable clip (2) to the engine wiring harness bracket.
5. Ensure that the engine wiring harness ground terminal (5) is position against the engine block.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
6. Position the negative battery cable ground terminal over the engine wiring harness ground and install the negative battery cable ground bolt (4).
Tighten the bolt to 25 Nm (18 lb ft).
7. Lower the vehicle.
8. Connect the engine wiring harness electrical connector (6) to the battery current sensor (5).
9. Install the negative battery cable integral bolt (4) to the battery tray.
Tighten the bolt to 40 Nm (29.5 lb ft).
