Canyon 4WD V8-5.3L (2009)
1. Position the wheel bearing/hub assembly on the brake rotor.
2. Install the mounting bolts from the wheel bearing/hub assembly to the brake rotor.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
Note: The following service procedure is to be performed on a flat surface and to ensure that the brake rotor is securely attached to the hub
assembly prior to the final torquing procedure. DO NOT use air tools of any type for this procedure.
3. Tighten the bolts in crisscross pattern. Tighten the mounting bolts to 20 Nm (15 lb ft).
4. Install the backing plate to the wheel bearing/hub, brake rotor assembly.
Note: The following service procedure applies to those vehicles that are equipped with 4 wheel drive ONLY.
5. Install the steering knuckle assembly. Refer to Steering Knuckle Replacement (See: Front Steering Knuckle/Service and Repair).
