Canyon 4WD V8-5.3L (2009)
3. Position the electrical harness grommet to the plenum panel hole (5).
4. Pull the harness toward the front of the vehicle in order to seat the harness grommet.
5. Connect the electrical connector.
6. Install the connector position assurance tab (CPA) to the harness connector.
7. Cycle the wiper system 1 time with the wiper motor switch.
8. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement (See: Body and Frame/Cowl/Cowl Moulding / Trim/Service and
Repair).
9. Install the wiper arms. Refer to Windshield Wiper Arm Replacement (See: Wiper Arm/Service and Repair).
10. Test the wiper system.
