Envoy 2WD L6-4.2L (2008)
Alarm Horn: Service and Repair
Theft Deterrent Alarm Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the spare tire, wheel and jack.
3. Disconnect the electrical connector from the theft deterrent alarm (3).
4. Remove the theft deterrent alarm mounting nut (1) from the crossmember support (2).
5. Remove the theft deterrent alarm (3) from the crossmember support (2).
Installation Procedure
1. Install the theft deterrent alarm (3) to the crossmember support (2).
Notice: Refer to Fastener Notice.
2. Install the theft deterrent alarm (3) to the crossmember support (2) with mounting nut (1).
Tighten the nut to 5 N.m (44 lb in).
3. Connect the electrical connector to theft deterrent alarm (3).
4. Install the spare tire, wheel and jack.
5. Lower the vehicle.