Envoy 2WD L6-4.2L (2008)
Trim Panel: Service and Repair
Body Side Window Rear Garnish Molding Replacement (TrailBlazer, Envoy )
Body Side Window Rear Garnish Molding Replacement (TrailBlazer, Envoy)
Removal Procedure
1. Remove the bolt that retains the seat belt upper anchor to the body.
2. Remove the garnish molding from the vehicle.
Installation Procedure
1. Install the garnish molding to the vehicle.
2. Install the seat belt retractor to the body.
Notice: Refer to Fastener Notice.
3. Install the bolt that retains the seat belt anchor to the body.
Tighten the anchor bolt to 70 N.m (52 lb ft).