Envoy 2WD L6-4.2L (2008)
3. Install the bolt that retains the rear seat belt upper guide to the body.
Tighten the rear seat belt upper guide shoulder bolt to 70 N.m (52 lb ft).
4. Install the screw that retains the rear upper quarter trim panel to the body.
Tighten the rear upper quarter trim panel screw to 2 N.m (18 lb in).
5. Install the cargo net retaining knobs.
Rear Window Garnish Molding Replacement
Rear Window Garnish Molding Replacement
Removal Procedure
1. Open the liftgate.
2. Release the clips that retain the garnish molding to the liftgate.
3. Remove the wire harness (1) from the slot located on the garnish molding.
4. Remove the garnish molding from the liftgate.
Installation Procedure
1. Position the garnish molding to the liftgate.
2. Install wire harness (1) into the slot located on the garnish molding.
3. Index the locating tabs to the corresponding holes in the liftgate.
4. Index the retaining clips to the liftgate.
5. Push the garnish molding into the liftgate in order to fully seat the retaining clips.
6. Close the liftgate.
Windshield Pillar Garnish Molding Replacement
Windshield Pillar Garnish Molding Replacement
Removal Procedure
