Envoy 2WD L6-4.2L (2008)
Seat Cushion: Service and Repair
Front Seat Cushion Cover and Pad Replacement
Front Seat Cushion Cover and Pad Replacement
Removal Procedure
1. Remove the 3 seat switch bezel screws.
2. Remove the 4 nuts that retain the seat pan to the seat adjuster assembly.
3. Remove the clip from the front outboard seat pan stud, if equipped. Discard the clip.
4. Release the J-strips (1, 3) on each side of the seat cushion.
5. Release the front/rear J-strips (2, 4).
6. Remove the supplemental inflatable restraint (SIR) electrical harness (2) from the seat pan.
7. Remove the seat electrical harness from the seat pan.
8. Remove the wire harness fasteners from the seat pan.
9. Disconnect the seat cushion heater electrical connector, if equipped.
Important: When separating the seat cover hook and loop retaining strips, do not pull the adhesive-backed strip from the seat pad.
10. Separate the hook and loop retaining strips.
