Envoy 2WD L6-4.2L (2008)
Important: Use care when installing the pad so the spreader springs are not excessively deformed.
2. Install the inboard brake pad.
Important: Use care when installing the pad so the spreader springs are not excessively deformed.
3. Install the outboard brake pad.
4. Rotate the brake caliper down into position.
Notice: Refer to Fastener Notice .
5. Install the lower brake caliper guide pin bolt.
Tighten the brake caliper guide pin bolt to 64 N.m (47 lb ft).
6. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
7. Lower the vehicle. Refer to Lifting and Jacking the Vehicle .
8. Fill the brake master cylinder reservoir. Refer to Master Cylinder Reservoir Filling (See: Hydraulic System/Brake Master Cylinder/Service and
Repair/Procedures/Master Cylinder Reservoir Filling) .
Caution: Refer to Firm Brake Pedal Caution .
9. Pump the brake pedal slowly and firmly to seat the brake pads.
10. Burnish the new brake pads. Refer to Brake Pad and Rotor Burnishing (See: Brake Pad and Rotor Burnishing) .
