Envoy 2WD L6-4.2L (2008)
Important: Ensure that the rotor to axle flange relationships marks are aligned, if the brake rotor has been refinished, after the brake
rotor is installed.
5. Install the brake rotor by slowly turning the rotor while pushing the rotor on the axle flange.
6. Install the rear brake caliper mounting bracket. Refer to Rear Brake Caliper Bracket Replacement (See: Brake Caliper/Service and Repair/Rear
Brake Caliper Bracket Replacement) .
7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
8. Lower the vehicle. Refer to Lifting and Jacking the Vehicle .
9. Refill the brake master cylinder reservoir, if needed. Refer to Master Cylinder Reservoir Filling (See: Hydraulic System/Brake Master
Cylinder/Service and Repair/Procedures/Master Cylinder Reservoir Filling) .
Caution: Refer to Firm Brake Pedal Caution .
10. Pump the brake pedal slowly and firmly in order to seat the brake pads.
11. Burnish replaced or refinished rotors. Refer to Brake Pad and Rotor Burnishing (See: Brake Pad/Service and Repair/Brake Pad and Rotor
Burnishing) .
