Envoy 2WD L6-4.2L (2008)
13. Disconnect the radiator side panels from the shroud (1).
14. Remove the radiator.
15. Remove the bolts retaining the condenser to the radiator.
Installation Procedure
1. Install the condenser to the radiator.
Notice: Refer to Fastener Notice .
2. Install the bolts retaining the condenser to the radiator.
Tighten the bolts to 28 N.m (21 lb ft).
3. Install the radiator.
4. Install the cooling fan and shroud. Refer to Cooling Fan and Shroud Replacement (See: Radiator Cooling Fan/Service and Repair) .
5. Raise the vehicle.
6. Install the outlet radiator hose (1) to the radiator.
7. Reposition the outlet radiator hose clamp (1) using J 38185 .
8. Connect the transmission cooler lines to the radiator. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and
Connection .
9. Install the lower radiator support shield, if equipped. Refer to Radiator Support Shield Replacement .
10. Lower the vehicle.
11. Install the coolant recovery hose to the radiator.
12. Install the radiator support diagonal brace. Refer to Radiator Support Diagonal Brace Replacement .
