Envoy 2WD L6-4.2L (2008)
10. Remove the remaining oil pan bolts.
11. Place 2 oil pan bolts in the jack screws on the oil pan and tighten evenly to release the oil pan from the engine (1).
12. Clean and inspect the oil pan.
Installation Procedure
Important: The oil pan must be installed within 10 minutes from when sealer was applied.
1. Apply a 3 mm (0.12 in) bead of sealer to the block, rather than the oil pan. Refer to Sealers, Adhesives, and Lubricants (See:
Specifications/Sealers, Adhesives, and Lubricants) .
Important: When you install the oil pan, it could be shifted front or back a little which could cause a transmission alignment problem.
The back of the oil pan needs to be flush with the block.
2. Install the oil pan, maneuvering the oil pan to clear the oil pump and screen assembly.
3. Install the oil pan bolts.
